This is the first episode in a series we're calling Quick and Dirty Moto DIY. We're changing wheel bearing on our Yamaha 700 Tenere. You need a long punch, a hammer, seal puller, assorted sockets (or bearing/seal driver set-up) as well as new bearing and seals.

The 700 Tenere uses the following bearing and seals:

*Front wheel
Front wheel bearings........22 x 44 x 12 60/22 2rs       x 2
Front seal......................... 30 x 44 x 5.                        x 2

*Rear Wheel
Rear wheel left................28 x 58 x 16      62/28  2rs    x 1
Rear wheel right..............20 x 47 x 14      6204 2rs      x 1
Sprocket carrier...............20 x 42 x 12       6004 2rs     x 1
Rear wheel left seal.........40 x 58 x 7                            x 1
Rear wheel right seal.......28 x 47 x 7                           x 1

For more of our adventures, check out our Facebook and our Instagram. :)